MikroTik Certified Enterprise Wireless Engineer – MTCEWE

Course Description

MikroTik Certified Enterprise Wireless Engineer ( MTCEWE ) is a high-level certification program designed to identify and serve the best of the Enterprise Wireless experts and to improve your hands-on skills. Boot-camp will be focused on most MikroTik advanced WiFi techniques.

Requirements

Participant should have MTCEWE Certificate.

What is the target audience?

By the end of this training session, the student will be familiar with wireless in MikroTik . He will also be able to configure outdoor wireless link , indoor access point, soft handover wireless client.

CURRICULUM

Section 1: Wireless Introduction

1. Wireless routers

2. RouterBOARD Wireless hardware

3. Wireless cards

Section 2: RF Wireless Characteristics

4. The RF Radio Spectrum and Electromagnetic Energy

5. Decibels

6. Antenna Theory and examples

7. 2.4/5GHz Indoor/outdoor cell sizes and transmitter powers

8. Client Roaming

9. RouterOS station roaming

10. Physical Network Infrastructure

Section 3: Wireless Standards

11. 802.11a/b/g/n/ac Wireless Protocol

12. 802.11 Standards Features Overview

13. Bands, Channels (Frequencies) and Channel Widths

14. Scan List

15. Modulation schemes and MCS data rates

16. Channel Bonding

17. Frame Aggregation

18. Chains (SISO, MIMO and MU-MIMO)

19. Priorities / WMM

20. Future Standards (802.11ax)

Section 4: Country / Regulatory Domain Settings in CAPsMAN

21. Antenna Gain and control of maximum EIRP

22. Setting antenna gain on CAP

23. Selecting the country code and purpose of 'installation' setting

24. Dynamic frequency selection (DFS radar detect)

Section 5: Non CAPsMAN Wireless Modes

25. Extending coverage with repeaters and extenders

26. Bridging with MikroTik 60GHz Wireless

27. 60GHz Wireless Wire products

Section 6: Wireless Security

28. Authentication (Open / Shared)

29. Encryption (WEP, WPA™ TKIP, WPA2™ AES)

30. Weaknesses of older encryption (WEP / WPA™ TKIP)

31. Overview of 802.11X (RADIUS and EAP)

32. Performance difference of TKIP vs. AES

33. Basic access list (ACL) management

34. Mitigating against most common known vulnerabilities of 802.11

Section 7: Wireless Troubleshooting

35. Troubleshooting wireless clients

36. Registration table analysis

37. TX/RX signal strength

38. Signal to noise ratio

39. CCQ, frames and HW frames, hardware retries

40. Data rates

41. Analysing the System log for wireless problems

42. Scan, background scan

43. Frequency usage

44. Wireless snooper

45. Wireless sniffer

Section 8: Wireless Surveys

46. Pre-install site surveys

47. Spectrum analysis overview

Section 8: WDS and MESH

48. Prediction software overview

49. Post-install validation surveys

Section 9: CAPsMAN v2

50. MikroTik CAPsMAN version 2 features

51. CAP hardware/software requirements

52. L2 (broadcast/multicast) vs L3 (via UDP) CAPs communication methods

53. Using DHCP option 138

54. Configuration of a CAP

55. CAPsMAN configuration settings (channels, datapaths, security configurations, data rates)

56. Provisioning CAP Interfaces (single and dual band APs)

57. Datapath / local forwarding

58. Dynamic vs static CAP interfaces on CAPsMAN

59. Virtual AP (additional SSIDs)

60. Static interfaces on CAPs (slave virtual interfaces with VLANs)

61. Access list features

MTCEWE EXAM

MikroTik Official Online Exam

On the last day of the training there will be an online exam of 60 minutes. (25 questions each.)
The passing grade is 60%, if you pass the exam your certificate will be immediately available in your MikroTik account (PDF format)
For those who score between 50-59%, will get a second chance. (Free of cost and the same day).
Please try the example test in your www.mikrotik.com account to get a better picture about the online exam.

Networking & Security

MikroTik

Cisco

Huawei

Juniper